sMg Guitars

November 18, 2012

Uke 1201:  Frets were radiussed then cut to length and placed in a holder.  Except for fret 2 and 11, the frets were hammered into place.

The fretboard was dry fit to the neck, and index holes drilled into the 2nd and 11th fret slots to hold the board in place for gluing.

Glue was applied to both the fretboard back and neck, then pressed into place using index pins.  The clamping is a big old rubber band wrapped around the neck several times.  The fretboard extention over the body is clamped down with a simple C clamp.