Guitar 1002 – Adapt to the Crack, Kerf
February 4, 2012
Well, the repaired crack didn’t survive. What I’ve done is attach the sides to the top and join the cracked section with a piece of engleman spruce backing. After the box is constructed, with both the top and the back attached to the sides, I will trim out the ragged edges, down to the spruce backing, and insert a binding bordered patch. Patch is the wrong word; inlay is better. The binding will match the body binding and the inlay will mimic the end graft, which I believe is rosewood.
The kerf for the top is installed, and once this dries, along with the spruce backing on the cutaway, I can begin to trim the sides in preparation for installing the back.
Jim on 06 Feb 2012 at 1:23 pm #
Wow! You’ve been busy. It’s starting to look like a guitar! I’m pretty excited. I think I’m going to like the look of that palo escrito. Too bad about the cracks in the cutaway, but we both knew that might happen, it’s a sharp bend. It sounds like you have it all under control. Cool. Thanks.