Guitar 1002 – Butt Block and Side Bend
January 29, 2012
I finished detailing the bracing on the top and trimmed back the ends to make room for the attachment of the sides to the top. The butt block was radiused and trimmed to length (about 1/8″ longer than actual) and glued to the top.
I also trimmed the sides to the same width as the butt block height then proceeded to bend the non-cutaway side.
After heating and bending, the side is allowed to cool, then the heat is turned back on for 15 minutes, then the side will sit in the mold overnight. After removal, it will need more hand bending to bring it to the desired curve to avoid having to spring the side into the workboard, which puts stress at the butt block and neck joint points which can cause splitting.
The cutaway side remains to be bent, but first I have to devise where the cutaway ram will be mounted on the bending machine. Hope I get it right. I’ve been avoiding this bend for months, and I am fully prepared to order new sides if I muck this up. So much for practicing on throwaway stock.